Motor Unit With Drill Attachment Pkga1 - Parkside PKGA 20-Li B1 Traduction Des Instructions D'origine

GB IE
If you place the direction switch
( 7) in the middle position, the de-
vice is secured against being switched
on.
Motor unit with drill
attachment PKGA1
Changing the tool
Secure the appliance against
switching on (see "Switch-
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
1. Rotate the keyless chuck (1) counter-
clockwise, until the drill chuck aperture
is large enough to accommodate the
tool.
2. Insert the tool as far as possible into
the keyless chuck (1).
3. Rotate the keyless chuck (1) clockwise
in order to clamp the tool.
4. To remove the tool again, rotate the
keyless chuck (1) and pull out the tool.
Choice of gear
Stop appliance before
changing gear.
1. Wait for the appliance to come to a
standstill.
2 Slide the gear selector (
required position:
1: low speed preselection.
2: high speed preselection.
Set the direction of rotation
The appliance's direction of rotation can
be changed with the rotational direction
switch.
42
1. Wait for the appliance to come to a
2. Push the rotational direction speed
3. If you place the direction switch
Torque adjustment
You can preselect the maximum torque.
The torque settings are labelled 1 - 19 +
1. Wait for the appliance to come to a
2. Turn the torque adjusting ring (2) to
3. Start with a lower torque step and
3) into the
standstill.
( 7) into the desired position:
Clockwise rotation:
screw in screws.
Anticlockwise rotation:
screw screws.
( 7) in the middle position, the device
is secured against being switched on.
The direction change may only be
actuated when at a standstill!
standstill.
select the desired torque:
Screws:
Steps 1 - 19
Drilling:
Step
increase as required.
The direction change may only be
actuated when the appliance is at a
standstill!
The necessary torque is dependent
on:
- the type and hardness of the ma-
terial to be treated;
- the type and length of the screws
used.
to drill and
to un-