Basic Configuration - AKO -16524A Guide Rapide

Alarms
Description
A0
Configuration of the temperature alarms 0=Relative to SP 1=Absolute
AL
A1 Alarm for maximum in probe 1 (It should be higher than the SP)
A2 Alarm for minimum in probe 1 (It should be lower than the SP)
A3
Delay of temperature alarms in the start-up
A4
Delay of temperature alarms from the end of a defrost
A5 Delay of temperature alarms from when the A1 or A2 value is reached
Delay of the external alarm/Severe external alarm on receiving a signal in digital
A6
input (I10 or I20 =2 or 3)
Delay of external alarm deactivation/Severe external alarm deactivation when the
A7
signal in digital input disappears (I10 or I20=2 or 3)
A8
Show warning if the defrost ends for maximum time
Relay alarm polarity
A9
A10
Differential of temperature alarms (A1 and A2)
A12 Delay of open door alarm (If I10 or I20=1)
EP
Exit to level 1

Basic configuration

Description
B00
Delay of all functions on receiving power supply
Bcn
B01
Cold room light timing
Function of password
B10
1=Block access to parameters
PAS
Access code (Password)
B20 MODBUS address
Communication speed:
B21
B22
Acoustic alarm enabled 0= No 1=Yes
Activation of manual calibration 0=Deactivated 1= Activated
B30
Requires security code, see page 25.
UNT
Work units
EP Exit to level 1
* According to wizard.
0= Relay ON in alarm (OFF without alarm);
1= Relay OFF in alarm (ON without alarm)
0=Inactive
2=Block keypad
0=9600 bps 1=19200 bps
2=38400 bps 3=57600 bps
0=ºC 1=ºF
30
Values Min.
ºC/ºF
ºC/ºF
Min.
Min.
Min.
Min.
0=No 1=Yes
ºC/ºF
Min.
Values Min.
Min.
Min.
bps
1652H4A11 Ed.08
Def. Max.
0 1 1
A2 99 99
-50 -50 A1
0 0 120
0 0 99
0 30 99
0 0 120
0 0 120
0 0 1
0 0 1
0.1 1.0 20.0
0 10 120
Def. Max.
0 0 255
0 0 999
0 0 2
0 0 99
1 1 247
0 0 3
0 1 1
0 0 1
0 0 1