Electromagnetic Compatibility; Electromagnetic Emissions - ACteon Piezotome Solo Manuel D'utilisation

XIII - ELECTROMAGNETIC COMPATIBILITY
Important:
The power cord, the ultrasonic handpiece cords and the multifunction footswitch cord must be kept away
from each other.
The device requires special precautions to be taken with regard to electromagnetic compatibility.
It must be installed and prepared for use as described in chapter 4.
Certain types of mobile telecommunication devices such as mobile telephones are likely to interfere with the
device.
The recommended separation distances in this paragraph must therefore be complied with.
The device must not be used near or on top of another device.
If this cannot be avoided, its operation under the conditions of use must be checked beforehand.
The use of accessories other than those speciÀ ed or sold by SATELEC as replacement parts may have the
consequence of increasing the emissions or decreasing the immunity of the device.

13. 1 ELECTROMAGNETIC EMISSIONS

The device is intended for use in the electromagnetic environment speciÀ ed in the table below. The user and/
or installer must ensure that the device is used in such an environment.
Emission test
RF emission - CISPR 11.
RF emission - CISPR 11.
Harmonic current emission
IEC 61000-3-2.
Voltage Á uctuation and
Á icker
IEC 61000-3-3.
Compliance
The device uses RF energy for internal operation.
Group 1 Therefore, its radiofrequency emissions are very low and are not likely
to cause any interference in nearby equipment.
Class B
The device is suitable for use in all establishments, including domestic
Class A
establishments and those directly connected to the public low voltage
power supply network that supplies buildings used for domestic
purposes.
Complies
Electromagnetic environment - guidance
15