Maintenance - Chauvin Arnoux LOCATO 110 Mode D'emploi

For maintenance, use only specified spare parts. The manu-
facturer will not be held responsible for any accident occurring
following a repair done other than by its After Sales Service or
approved repairers.
CHANGING THE BATTERY
The 9 V battery is accessible at the back of the Receiver.
Remove the back section of the case after having undone the screw.
Pull off the standard 9 V battery connector.
WARNING:
Always replace the fuse with another of the same type and
value : FF 0,1A 380V (5 x 20 mm) 10kA
CHANGING THE FUSE
To change the HBC fuse of the Emitter, remove the two screws from the case.
STORAGE
If the instrument is not put into service for a time exceeding 60 days,
remove the batteries and store them separately.
CLEANING
- The instrument must be disconnected from any electrical source.
- To clean the case, use a cloth slightly moistned with soapy water. Rinse
with a damp cloth. Then, dry rapidly with a cloth or in a hot air stream.
CALIBRATION
It is essential that all measuring instruments are regularly calibrated.
For checking and calibration of your instrument, please contact our
accredited laboratories (list on request) or the Chauvin Arnoux subsidiary
or Agent in your country.
REPAIRS
Repairs under or out of guarantee: please return the product to your distributor.

MAINTENANCE

48