Hella KLED 2.0 Instructions De Montage page 18

APPROVAL
Hella rotating beacons
(K-LED 2.0 Art. No. 2XD 011 557-
XXX, yellow, red, blue) have been
offi cially type-tested within the
scope of ECE-R65. They need to
be mounted at the highest point of
INSTALLATION
A
18
r > 3000 mm
Select the proper position on the
roof of the vehicle (see specifica-
tions). If the specified visibility (see
German Road Traffic Licensing
Regulations - StVZO) cannot be
satisfied due to structures on the
roof of the vehicle, further beacons
must be mounted.
M5 screws must be used for
attaching them from below.
Screws, see drawing.
the vehicle and, when the vehicle
is loaded during operation, they
must be vertical to the road sur-
face. All rotating beacons are RFI
suppressed and comply with VDE
0879 Part 2. They are EC-approved
according to Directive 72/245 EEC in
version 2006/28 EC.
Type approval ECE-R65
Type approval ECE-R10
Approval
> 0,6 mm
Rated voltage
Operating voltage
Total current consumption
Interference suppression class CISPR 25 Degree of interference suppression 5
Power consumption
Dome
Operating position
Protection class
Temperature range
Reverse polarity protection
Casing
Interference suppression class
ELECTRICAL CONNECTION
(fuse-protected positive line)
Use a cable cross-section of at least
2
1.5 mm ,
10 slow-blow fuse.
Technical Data
GGVSE / ADR
12 V/24 V
10-32 V
12 V: approx. 0.85-2.5 A
24 V: approx. 0.45-1.25 A
approx. 9-30 W
PC
upright
IPX 9K, IP 6K
minus 40 ºC to plus 60 ºC
Yes
Aluminum
e1 Approval according to 72/245 EEC
in version 2006/28 EC.