Attaching The Belt Cover; Attaching The Needle - JUKI MH-481 Manuel D'utilisation

5. ATTACHING THE BELT COVER

WARNING :
To avoid possible personal injury due to abrupt start of the machine, turn off the power to the machine and check to be
sure that the motor has totally stopped rotating in prior.
1
4

6. ATTACHING THE NEEDLE

WARNING :
To avoid possible personal injury due to abrupt start of the machine, turn off the power to the machine and check to be
sure that the motor has totally stopped rotating in prior.
1
Use a TV×7 needle.
Different needle counts are applicable. However, select an appropriate one according to the thickness of thread
and the type of material to be used. (#9 to #21)
1) Turn the handwheel to bring the needle bar to the highest position of its stroke.
2) Loosen needle clamp screw 2 . Hold needle 1 so that its scarf faces toward the feeding direction of material.
3) Insert needle 1 fully into the needle clamp hole until it comes in contact with the deep end.
4) Firmly tighten needle clamp screw 2 .
Attach the needle so that its eyelet faces toward A for fi lament thread, or B for cotton thread so as to prevent stitch
skipping of needle thread.
To carry out reverse-feed stitching with consistency, do not allow the needle eyelet to face toward C.
6
5
2
3
6
5
2
Feed direction
1. Insert belt cover support 1 into the tapped hole in
the machine arm.
2. Temporarily fi x belt cover 2 on the machine head
with screws.
3. Slightly tilting the machine head, put rid 3 of the
belt cover inside the outer pulley and fi x rid 3 with
four screws.
4. Fix rid 3 on support 1 .
5. Loosen the screws in the belt cover, and adjust the
position of belt cover 2 properly. Then securely
tighten the screws in the belt cover.
6. Fix bobbin winder cover 4 with three screws.
7. Fix belt cover auxiliary plate 5 as illustrated in the
fi gure.
(Caution) 1. When tilting the machine, loosen
wooden screw 6 in belt cover auxil-
iary plate 5 and move the auxiliary
plate in the direction of the arrow to
such an extent that it does not come
in contact with the belt cover as
shown in the fi gure.
2. After you have raised the machine,
return belt cover auxiliary plate 5 to
the previous position.
– 6 –
Feed direction