Installation - JUKI MH-481 Manuel D'utilisation

1. INSTALLATION

2
1
3
4
Operator's side
7
7
8
6
4 5
Hinge side
7
1) Carry the sewing machine with two persons.
(Caution) Do not hold the handwheel.
2) Do not put protruding articles such as the screw-
driver and the like at the location where the sewing
machine is placed.
3) Attaching the hinge seats and the support rubbers of
the machine head
Fix the hinge seats 1 supplied with the machine on
the table using nails 2 .
4) Attaching the oil pan
Install the oil reservoir 6 in the way that it is sup-
ported by four corners of the opening in the table. Nail
two rubber cushions 3 to a protruded edge from the
table opening at operator's side using nails 4 and also
attach two head-rest cushions 5 to a protruded edge at
the far end (hinge side) using nails 4 , and the place oil
reservoir 6 on the cushions.
5) Fit hinge 7 into the opening in the machine bed,
and fi t the machine head to table rubber hinge
before placing the machine head on rubber seats on
the four corners.
6) Securely attach head support rod 8 to the table
until it goes no further.
– 2 –