Festool CMS-OF Notice D'utilisation D'origine/Liste De Pièces De Rechange page 13

Module mounting CMS-OF
Table of contents
1 Symbols
2 Technical data
3 Scope of delivery
4 Intended use
5 Safety instructions
6 Set-up and assembly
7 Adjustments
8 Operation
9 Accessories
10 Disposal
11 Warranty
12 Declaration of Conformity
The specifi ed illustrations are at the beginning of
this operating manual.
1 Symbols
Warning of general danger
Risk of electric shock
Wear a dust mask!
Read the operating instructions/notes
Advice or tip
2 Technical data
Bench dimensions
Bench height with foldaway legs
Bench height without foldaway legs
Max. routing tool diameter
Max. routing tool height
Module mounting weight
Workpiece dimension, max. L x W x H
650 mm x 160 mm x 65 mm
3 Scope of delivery
[1-1] M o d u le m o u n t i n g C M S - O F 1 0 1 0 /
1400/2200 with height adjustment
[1-2] Router stop
[1-3] Press-down fi xture
[1-4] Centring and reducing rings
[1-5]
[1-6]
[1-7]
[1-8]
[1-9]
[1-10] Adjustment plate
4
The module mounting CMS-OF was designed for
Festool routers OF 1010, OF 1400 and OF 2200,
but not for router OF 2000. The Festool routers
listed above can be used for stationary applica-
tions when combined with the module mounting
and the basic unit CMS-GE.
Do not install any routers other than those listed
above. The user bears the responsibility for dam-
age and accidents caused by improper use.
5
5.1
stand and the power tool to be mounted. Failure
to follow the warnings and instructions may result
in electric shock, fi re and/or serious injury.
Save all warnings and instructions for future
reference.
The term „power tool" in the warnings refers
to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
- Disconnect the plug from the power source
and/or the battery pack from the power tool
before making any adjustments or changing
accessories. Accidental starting of the power
tool is a cause of some accidents.
585 x 400 mm
- Properly assemble the working stand before
900 mm
mounting the tool. Proper assembly is impor-
316 mm
tant to prevent risk of collapse.
60 mm
- Securely fasten the power tool to the working
60 mm
stand before use. Power tool shifting on the
4.65 kg
working stand can cause loss of control.
- Place the working stand on a solid, fl at and
level surface. When the working stand can shift
or rock, the power tool or workpiece cannot be
steadily and safely controlled.
- Do not overload the working stand or use as
ladder or scaffolding. Overloading or standing
on the working stand causes the stand to be
"top-heavy" and likely to tip over.
13
Guide rail
Curved guard
Protective cover for OF 2200
Crank handle for height adjustment
Clamping supports
Intended use
Safety instructions
General Safety instructions
WARNING Read all safety warnings and all
instructions provided with the working