Brandt BFC644YNW Manuel D'instruction page 83

The motor runs
continuously
A layer of frost
occurs in the
compartment
Temperature inside
is too warm
Temperature inside
is too cold
Doors cannot be
easily closed
easily
Water drips on the
floor
The light is not
working
lt is normal to frequently hear the sound of the
motor, it will need to run more when in following
circumstances:
•Temperature setting is set colder than necessary
•Large quantity of warm food has recently been
stored within the appliance.
•The temperature outside the appliance is too high.
•Doors are kept open too long or too often.
•After you have installed the appliance or it has
been switched off for a long time.
Check that the air outlets are not blocked by food
and ensure food is placed within the appliance to
allow sufficient ventilation. Ensure that door is fully
dosed. To remove the frost, please refer to cleaning
and care chapter.
You may have left the doors open too long or too
frequently; or the doors are kept open by some
obstacle; or the appliance is located with insufficient
clearance at the sides, back and top
Increase the temperature by following the "Display
controls" chapter.
Check that the air outlets are not blocked by food
and ensure food is place within the appliance to
allow sufficient ventilation.
Ensure that the door is fully closed.
The water pan (located at the rear bottom of the
cabinet) may not be properly leveled, or the draining
spout (located underneath
compressor depot) may not be properly positioned
to direct water into this pan, or the water spout is
blocked. You may need to pull the refrigerator away
from the wall to check the pan and spout.
•The LED light may be damaged. Refer to replace
LED lights in cleaning and care chapter.
•The control system has disabled the lights due to
the door being kept open for too long. Close and
reopen the door to reactivate the lights.
the top of the
27