Brandt BFC644YNW Manuel D'instruction page 66

Note: Before you start, lay the
refrigerator on its back in order to
gain access to the base. You should
rest it on soft foam packaging or
similar material to avoid damaging
the backboard of the refrigerator. To
2. Open part
refrigerator body from right side and
then lake down part
the upper door in the same way. Take
down part and put it back in the
plastic bag.
3. Disconnect electrical connector
well as electrical connector
take down part .
on top of the
and part on
as
and then
reverse the door, the following steps
are generally recommended.
1. Place the refrigerator upright.
Open the upper door to lake out all
door racks (to avoid racks damaged)
and then close the door.
4. Remove the screws
. and remove part
Note: Please hold the upper door by
hand during step 4 to prevent the door
from falling.
5. Remove the upper door and place it
on a smooth surface with its panel
upwards. Lever part
loose screws , as shown in the
picture. Change handle
side, then install screws , part
part in turn. Loose screws , detach
part and part
and another part
to the left side with screws . Put part
just detached back into the plastic
bag.
loose wire
.
and part .then
to the right
and
then install part
(in the plastic bag)
10