Brandt BFC644YNW Manuel D'instruction page 68

7. Place the lower door on a smooth
surface with its panel upwards.
Change the handle to the right side
according to step 5. Loosen screws
, detach part and part . Turn part
by 180"and then install part
part to corresponding position on
left side together with screws .
8. Change screw hole covers on
middle cover plate from left to right
(as shown in figure below).
9. Place refrigerator flatwise, remove
part and then loosen screws
Remove part and part .
10. Screw out lower hinge, change it
and
to the near hole site, and then screw
up and mount washer.
11. Just remount to the step 9,
change part
right and then fix them with screws
. Finally install part .
12. Move the lower door and adjust
its position to align lower hole site and
upper hinge axis. Tum the middle
hinge by 180, change the washer on
the axis to the upper side, adjust the
middle hinge to the appropriate
position and then install it.
13. Screw out The upper hinge axis,
turn the upper hinge over and fix axis
on it. Then place it on the side for
later use.
to left and part
12
to