Windows® Server 2003 Driver Installation; New System Installation - Dell LSI21320-IS Guide De Démarrage Rapide

Quick_Start_Guide_IS.book Page 19 Thursday, May 15, 2003 4:53 PM
Click the Next button again to start the driver update.
6
In some cases, a message will display saying that this driver is not
digitally signed. This message informs you that a non-signed driver is
being installed.
Click No to cancel the installation if the non-signed driver is not
7
desired.
or
Click Yes to continue the installation.
The system loads the driver from the Windows 2000 driver diskette
and copies the driver to the system disk.
For any adapter other than the boot adapter, the updated driver
becomes active immediately. For the boot adapter, a message box
displays indicating that you must reboot your system for the new
driver to take effect.
Click the Finish button to complete the driver upgrade.
8
®
Windows
Installation
This procedure installs the SYMMPI.SYS driver onto a new or existing
Windows Server 2003 system. You will receive a driver diskette that
contains all the drivers for the various Windows operating systems with
your system purchase or as part of your upgrade kit. This driver may also be
found on the CD that shipped with your system or may be found at the Dell
support website at support.dell.com. This driver diskette will provide a
choice for which driver version to install. You will use this diskette during
the installation process.

New System Installation

This procedure installs the SYMMPI.SYS driver onto a Windows Server
2003 system. Use this procedure when installing Windows Server 2003
software onto an unused drive. Windows Server 2003 software
automatically adds the driver to the registry and copies the driver to the
appropriate directory.
Server 2003 Driver
Integr ated Striping Quick Start Guide
19