E. Timer
indicate timer on/off time (0÷23:50 hours).
F. Fan speed
Displays the fan speed set, aUto and three speed levels can be indicated
"
" (loW) - "
"AUTO" is displayed when the operational mode is "AUTO" or "DRY".
G. Sleep
Displayed under sleeping operation.
Press the SleeP button again to remove.
The remote control display is illustrated just for greater clarity.
3.4.2 - Description of the remote control keys (figure 34)
1. MODE SELECTION key
every time this key is pressed, a mode is selected in sequence,
AUTO > COOL DRY > HEAT > FAN and then back to AUTO.
2. ON/OFF key
Press this key to start the appliance and press it again to stop the appliance.
3. SWING key
Press this key to start the louvres and press it again to stop them.
4. TEMP/TIME key
Press the
key to increase the indoor temperature set or to adjust the timer in a clockwise direction.
Press the
key to lower the indoor temperature set or to adjust the timer in an anti-clockwise direction.
5. FAN key
Used to select fan speed, it has four levels aUto, loW, meD or HiGH.
the fan speed changes every time this key is pressed.
6. TURBO/SELF CLEAN key
Press this key for less than 2 seconds to start the tUrBo function.
if the key is held down for more than 2 seconds, the Self Clean function is activated.
3.4.3 - Follow Me function
the remote control acts as a remote thermostat, allowing correct control of the temperature in its position.
• To activate the Follow Me function, point the remote control towards the unit and press the "follow me"
button.
the remote control displays the real temperature in its own position and sends this signal to the air
conditioner every 3 minutes, until the button is pressed again.
if the unit does not receive the follow me signal for 7 minutes, it emits a "beep", which signals that the
follow me mode has ended.
The Follow Me function is not available in the DRY and FAN mode.
• if the operating mode is pressed, or the unit is switched off, the follow me function is annulled automatically.
EN - 28
" (meD) - "
" (HiGH).