Rating Plate Cover - clage MCX Série Instructions D'utilisation Et D'installation

Masquer les pouces Voir aussi pour MCX Série:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 34

12. Rating plate cover

10
11
Removing the cover
The rating plate and the adjusting screw for flow rate setting
are located under this cover.
1. Push the cover at the corrugation towards the wall bracket.
2. Press the cover down at the rear corners until the front
edge lifts.
3. Remove the cover by pulling forward.
Rating plate cover
On the inner part of
the cover, you can find
the name of the appli-
cation type (1), as well
as the serial number
(2) and the article
number (3).
Replacing the cover
1. Push the cover flat towards the wall bracket under the
edges of the water connections.
2. Press down the front edge of the cover and push it forward
again at the rear edge until it fits.
29
1
Gerät an Schutzleiter
MCX 3
anschließen!
Appliance must be earthed!
CLAGE GmbH
21337
Lueneburg
GERMANY
CLAGE
EN
2
3
1500-15003
012345-012345
MADE IN
GERMANY

Publicité

Table des Matières
loading

Table des Matières