Amprobe AT-5000 Mode D'emploi page 14

• Push the up/down arrows to select the desired frequency.
• Push Select to activate the desired frequency.
• Push the Signal Select
frequency is marked with an X. An operator can activate the Signal Select feature for all available frequencies even if the
frequency is not currently selected for use.
• Repeatedly pushing the
the selected frequency. The output can be increased in 1X, 2X, 5X, or 10X increments up to 1A or 10W, respectively.
• Push Menu or Select to return to the frequency settings menu screen.
• Push Menu to return to the operational display screen.
frequency Menu - Inductive Coupling with Clamps
Inductive coupling with Amprobe clamps SC-5000 enables the operator to induce a signal onto the target conductor. It allows the
operator to configure one active frequency for operation – 9.82 kHz or 82.488 kHz.
frequency Menu – Inductive Coupling with the Signal Select™ Clamp
The desired clamp frequency is configured using the three-button navigational keypad.
• Push Select to activate the desired frequency.
• Push Menu to return to the frequency settings menu.
The desired frequency is configured using the three-button navigational keypad.
• Push the up/down arrows to select the desired frequency.
• Push Select to activate the desired frequency.
• Repeatedly pushing the
the selected frequency. The applied output can be increased incrementally by 10%, 25%, 50%, 75%, or 100% of maximum
power.
• Push Menu or Select to return to the frequency settings menu screen.
• Push Menu to return to the operational display screen.
• Push the Signal Select button
the operational display screen when activated.
frequency Menu - Inductive Antenna Connection Mode
Inductive antenna connection mode enables the operator to select one active frequency.
The desired frequency settings menu is configured using the three-button navigational keypad.
• Push Select to open the inductive frequency settings menu.
button to activate or deactivate the Signal Select feature if available. The activated Signal Select
output level control
output level control
to activate or deactivate the Signal Select feature. The Signal Select icon is displayed on
button allows the operator to configure the output current or power of
button allows the operator to configure the output current or power of
12