Programming; Programming Doses; Programming Coffee Doses - Nuova Simonelli OSCAR II Manuel D'instructions

3.

PROGRAMMING

3.1

PROGRAMMING DOSES

Carry out the following operations to enter into programming
mode:
NOTE: Operation to be carried out with the machine
switched on.
• To enter into programming mode, press the
two coffee dispensing button for 5 seconds.
• The dispensing buttons start to flash.
NOTE: After 30 seconds of inactivity (no buttons pressed)
in programming mode, the machine returns to
normal mode and no data is memorised.
3.2 PROGRAMMING COFFEE
DOSES
To programme the dose of water relative to one of the
dispensing buttons, proceed as follows:
• Fill the filter holder with the correct dose of coffee (the
filter holder can be single or double depending on the
button to be programmed).
• Place the filter holder into the unit.
• Press one of the dispensing buttons.
• Dispensing starts; once the desired quantity has been
reached press the same button again.
• To exit from the programming mode and memorise
the desired doses, keep the
for at least 5 seconds; the buttons stop flashing.
22
button pressed