System Commands - Balluff BML SL1-ALZ-ZZ Série Notice D'utilisation

BML SL1-ALZ _-_ _ ZZ- _ _ _ _ - _ _ _ _
Absolute Magnetically Coded Position Measuring System
7
IO-Link Smart Sensor profile Ed. 2 (BML SL1-ALZ1-UE/MZZ-_U1L-...) (continued)
7.4

System commands

Different commands have been implemented in the BML
which can be reached via the parameter System
Command on Index 2, Subindex 0. If a System Command
is sent to the BML, the command triggers the desired
action as long as it is permitted in the current application
condition.
Command Name
0x01 (1) ParamUploadStart
0x02 (2) ParamUploadEnd
0x03 (3) ParamDownloadStart
0x04 (4) ParamDownloadEnd
0x05 (5) ParamDownloadStore
0x41 (65) SP1 Single Value Teach
0x42 (66) SP2 Single Value Teach
0x4E (78) Teach Reset
0x80 (128) Device Reset
0x82 (130) Restore Factory Settings
0xA5 (165) Reset Maintenance
0xE0 (224) Teach Preset
0xE1 (225) Teach Measurement
Range Lower Limit
0xE2 (226) Teach Measurement
Range Upper Limit
Tab. 7-5: System commands Index 2, Subindex 0
www.balluff.com
Description
Starts parameter upload.
Ends parameter upload.
Starts parameter download.
Ends parameter download.
Finishes configuration and starts data storage.
Stores the currently measured position as Setpoint 1.
Stores the currently measured position as Setpoint 2.
Deletes the SP1- and SP2 value of all SCCs.
Reinitializes all device components.
Resets all configurations to their factory defaults.
Resets all operating parameters.
Calculates and stores the PDV offset, sets the current output value to the
preset value.
Teaches the current position as the lower limit value of the measuring area
(see Section 7.5.1).
Teaches the current position as the upper limit value of the measuring area
(see Section 7.5.1).
english 27