Installation Of Release Box For Manual Drive; Final Checks - Erreka ARC Mode D'emploi

INSTALLATION
6

INSTALLATION OF RELEASE BOX FOR MANUAL DRIVE

7

FINAL CHECKS

Closing force check

Installation must respect the values indicated
in Standard EN 12453:2000. All measurements
must be made in line with the method
described in Standard EN 12445:2000.
• F < 400N in spaces between 50mm and
d
500mm
• F < 1400N in spaces > 500mm
d
34
Installation Manual

Release for manual drive can be carried out in two
manners:
• By way of key: see "Manual operation" on page 29.
• By way of release box: a release box must be
installed, as shown below:
1 Remove the rim (1).
2 Position the spring (2) and introduce the release
cable (3) and its cover (4).
3 Install the release box. Check the release box
instructions manual.
User instruction
1 Instruct the user with regards to the use and
maintenance of the installation and provide him/her
with the use manual.
2 Signpost the gate,
automatically and indicating how to operate it
manually. Where appropriate,
operation is using the remote control.
showing that it opens
indicate that