Installation; Tools And Materials; Initial Conditions And Checks - Erreka ARC Mode D'emploi

INSTALLATION

1

TOOLS AND MATERIALS

Screwdrivers
Fixed wrenches (13 mm)
2.5 mm and 4 mm Allen keys
Marker pencil
Spirit level
Tape measure
2

INITIAL CONDITIONS AND CHECKS

Initial conditions of the gate

Check that the size of the gate is within the
admissible range of the actuator (see the
technical characteristics of the actuator).

If the gate to be automated has a passage gate,
use a safety device to prevent the actuator
from operating with the passage gate open.

The gate must have a closing stopper. When
installing an articulated arm, it is necessary to use
the opening and closing stopper.
Environmental conditions

This device is not suitable for installation in
inflammable or explosive environments.
Electrical power supply installation

The electrical connections shall be made in line
with the instructions in the control panel
manual.
30
Installation Manual
Electric drill and broaches

Use the electrical drill in line with the use
instructions.
Screws to attach the actuator bracket and the arm
bracket

The gate must be easy to manipulate manually,
namely:
• It must be balanced, in order to ensure the effort
made by the motor is minimum.
• There should be no stiffness throughout its travel.

Do not install the actuator in a gate which does
not work correctly in manual operation, as this
may lead to accidents. Repair the gate before
installing.

Check that the admissible environmental
temperature range for the actuator is suitable
for the location.

The electrical cable section is indicated in: "Fig. 1
Elements of the complete installation" on page 27.