To Ensure Safe Use
Danger of electrical short, shock, electrocution, or fire
This machine carries a high current of a maximum of approximately 10 amperes. This can cause situations
that could not occur with low-power equipment; use caution.
WARNING
Do not use with any electrical power
supply that does not meet the ratings
displayed on the unit.
Use with any other power supply may lead to
fire or electrocution.
Never operate the machine or insert
or remove its power plug with wet
hands.
Doing so may result in electrical shock or elec-
trocution.
Never allow the machine to get wet,
or apply gasoline, thinner, or any other
flammable material to it.
Current leakage may cause electrical shock,
electrocution, or combustion and fire.
Never allow hairpins, coins, matches,
or any other object to get inside the
machine through the ventilation ports.
Doing so may cause and electrical short, re-
sulting in shock or electrocution, or the in-
serted object may catch fire.
Never place gasoline, alcohol, thinner,
or any other flammable material near
the machine, or use an aerosol spray
close to the machine.
Doing so may cause fire.
Never damage the power cord or pull
it with force.
Doing so may tear the cord's insulation, caus-
ing an electrical short and resulting in electri-
cal shock, electrocution, or fire.
Never place any object on the power
cord, bend the power cord using ex-
cessive force, or allow the power cord
to become deformed.
The cord carries a high current of approxi-
mately 10 amperes. If it becomes deformed, the
deformed location may grow hot and cause fire.
6
Never use the machine with the power
cord bound into a bundle or roll.
The cord carries a high current of approxi-
mately 10 amperes. If the cord is in a bundle
or roll, it may grow hot and cause fire.
Never use any power cord other than
the power cord included with the ma-
chine. Also, never use a power strip or
extension cord.
The cord carries a high current of approxi-
mately 10 amperes. The power strip or exten-
sion cord may grow hot and cause fire.
Do not use with a damaged power cord
or plug, or with a loose electrical out-
let.
Doing so may lead to fire, electrical shock, or
electrocution.
When unplugging the electrical power
cord from the power outlet, grasp the
plug, not the cord.
Unplugging by pulling the cord may damage it,
leading to fire, electrical shock, or electrocu-
tion.
Ground the unit with the ground wire.
Failure to do so may result in risk of electro-
cution in the event of a mechanical problem.
In the event of an abnormal state (such
as smoke or sparks, odor or burning
or unusual noise), immediately unplug
the power cord.
Failure to do so may result in fire, electrical
shock, or electrocution. Immediately discon-
nect the power cord and contact your Ro-
land DG Corp. service center.