Vortice VORT PROMETEO PLUS HR 400 Notice D'emploi Et D'entretien page 19

ENGLISH
Residual operating time at Vmax,(Fig.5e;
5e 5e
depending on preset Timer duration (see TIMER
button)
Other information displayed automatically, depending
on the conditions:
Excess CO 2 threshold warning (see "Warning/error
signals")
Value set during initial configuration of Min and Max
Speed (values Min from 00 to 69, Max from 10 to 99
: only during the installer set up stage)
Clockface symbol: if the Timer function is set (see
"TIMER button")
Clogged filters (see "Warning/error signals")
Battery charge low (see "Warning/error signals")
System malfunction (see "Warning/error signals")
TIMER button (fig.6)
6 6
DISPLAY
SET
It forces the device to operate at Max Speed for 10
min (press key for 0.5 sec), 20 min (press twice), 30
AUTO
Su
TIMER
MODE
NEXT ENTER
min (press three times), or continuosly (press four
times). Pressing the key for a fifth time restores
operation at the previously set speed, unless over-
ridden by the sensors. The display will also show
(fig.6a):
6a 6a
• The TIMER icon;
• The duration set (10,20,30,CO;
If the programming time has elapsed (or if you press
the TIMER key five times repeatedly until OFF), the
appliance will go back to the previously set function
mode.
MODE button (fig.7)
7 7
DISPLAY
SET
Allows the available operating modes (MAN, BP,
AUTO) to be selected. Press the key to switch
between modes.
AUTO
Su
MODE
TIMER
NEXT ENTER
19