switel WTF732 Mode D'emploi page 61

Confirmation signal (Roger beep)
The confirmation signal is issued on releasing the P button. This signals to the
caller that you have ended transmission.
Activating/Deactivating the confirmation signal
35
9 x M
+/,, P
Key tone on/off
10 x M
+/,, P
Dual channel monitoring
It is possible to monitor a second channel with CTCSS/DCS code in addition to the
currently set channel with CTCSS/DCS code.
Activating dual channel monitoring
11 x M
+/,, M
+/,, M
+/,, M
Both channels are scanned for signals. If an active channel is detected, the dual
channel scan stops. Channel scanning is resumed when no signal has been trans-
mitted on the channel for five seconds.
Press the P button to enable radio communication on this channel.
Deactivating dual channel monitoring
11 x M
+/, [ OF ], P
Operating the Walkie−Talkies
Activate the programming mode
Select ON / OF and confirm it
Activate the programming mode
Select ON / OF and confirm it
Select dual channel monitoring
Select the 2nd channel and confirm it
Select the CTCSS code for the 2nd channel and
confirm it
Select the DCS code for the 2nd channel and
confirm it
Select dual channel monitoring
Deactivate dual channel monitoring
61