Operation; Starting/Stopping The Caulking Gun; Maintenance And Cleaning; Storing - Batavia MAXX Série Mode D'emploi

8. Operation

Pull the rack rod back by the handle (3)
8.1
to the end of the cartridge holder (1).
Put the cartridge onto the cartridge
8.2
holder.
Push the rack rod (2) forward until it is
8.3
against the back of the cartridge.
Press the trigger switch (5) until the
8.4
material within the cartridge comes out
form the nozzle of the conical
applicator.
Release the trigger switch (5) to turn off
8.5
the caulking gun.
Note: When the rack rod handle reaches the
location switch, it will automatically stop.
9. Starting/Stopping the caulking
gun
To turn the caulking gun ON, depress
9.1
the switch trigger (5).
To turn the caulking gun OFF, release
9.2
the switch trigger (5).
For continuous operation just press the
9.3
lock-on button (4) on the left side of the
handle. The lock-on button can be
release by pressing the switch trigger
again.

10. Maintenance and cleaning

WARNING: Remove the batteries before
carrying out any maintenance/ cleaning of
the tool.
Maintenance
10.1
There are no inner parts of the tool which
need maintenance.
Cleaning
10.2
• Keep safety devices, ventilation open-
ings and the motor housing as free as
possible from dirt and dust. Rub the
electric power tool with a clean cloth or
blow over it with low pressure com-
pressed air.
• We recommend that you clean your
electric power tool immediately after
each use.
• Clean the electric power tool regularly
with a damp cloth and somewhat soft
soap.
Do not use any cleaning or solvent materi-
als; these can attack the device's plastic
components. Make sure that no water can
get inside the electric power tool.

11. Storing

• Clean the device before storing it.
• Before storing check all parts for
damages.
• Store the device indoors in dry place
that is protected from dust and dirt and
extreme temperatures.

12. Technical data

Rated voltage . . . . . . . . . . . . . .6 V DC
Cartridge size . . . . . . . . . . max. 300 ml
Extrusion speed no load . max. 70 mm/min
Extrusion force. . . . . . . . . . . . . .75 kgs
Sound pressure level L
Uncertainty K . . . . . . . . . . . 2.58 dB(A)
pA
Sound power level L
Uncertainty K . . . . . . . . . . 2.58 dB(A)
WA
Hand/arm vibration . . . . . . . . . 0.75 m/s
Uncertainty K. . . . . . . . . . . . . 1.19 m/s
Dimensions . . . . . . . 36 × 6.5 × 22.5 cm
Net weight (without battery) . . . . . . 912 g
* Sound and vibration emissions may differ
from the declared values during use
depending on the ways in which the tool is
used.
Vibration level
12.1
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given
in EN 60745; it may be used to compare one
tool with another and as a preliminary
assessment of exposure to vibration when
using the tool for the applications
mentioned
• using the tool for different applications,
or with different or poorly maintained
accessories, may significantly increase
the exposure level
• the times when the tool is switched off
or when it is running but not actually
doing the job, may significantly reduce
the exposure level.
Protect yourself against the effects of vibra-
tion by maintaining the tool and its accesso-
English
. . . . 42.09 dB(A)
pA
. . . . . . . 47 dB(A)
WA
2
2
7