Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
instructions and also the enclosed safety
instructions.
Always check that the power supply
corresponds to the voltage on the
rating plate.
Class II machine – Double insulation
– You don't need any earthed plug
Replacing cables or plugs
If the power cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person, in order to
avoid a hazard.
Immediately throw away old cables or plugs
when they have been replaced by new ones. It
is dangerous to insert the plug of a loose cable
in the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The mini-
mum conductor size is 1.5 mm
cable reel always unwind the reel completely
Inadequate extension cords can be danger-
ous. If an extension cord is used, it shall be
suitable for outdoor use, and the connection
has to be kept dry and off the ground. It is
recommended that this is accomplished by
means of a cord reel which keeps the socket
at least 60 mm above the ground.
CONTENTS
1 Weed Killer
1 Nozzle for weed control
2 Nozzles for paint removal
1 Nozzle for BBQ
1 Extension handle (2 parts)
1 Instruction manual
PRODUCT
Fig. A
1.
On / off switch
2.
Temperature switch
3.
Ventilation openings
4.
Hot Air nozzle
5.
Extension handle
6.
Handle
7.
Lock button for extension handle
8.
Lock button for revolving handle
7062246_Maxxheat_Ma_#1503-18.indb 15
9.
Cap
10. Stand
11. Nozzle for weed control
12. Flat nozzle for paint removal
13. Glass protection nozzle for paint removal
14. BBQ / fireplace nozzle
OPERATION
Temperature settings:
With the temperature switch you can select
from three temperature settings. Depending on
the application, you can use the following
settings:
Setting I 50 °C (venting / cooling)
Setting II 400 °C
. When using a
2
Setting II 600 °C
The volume of air in each setting 500L /Minute
To turn on the power:
–
Press the on / off switch (1)
To turn off the appliance:
–
Press the on / off switch (1) again. The unit
is now switched off.
To install the nozzle:
The nozzles can easily be pushed over the hot
air nozzle. Never touch the nozzles during or
immediately after use of the device. The
nozzles are very hot.
Rotating handle:
The device has two handle positions (see Fig.
D) Position 1 is suitable for killing weeds and
igniting the BBQ. In position 2, the device can
be used as a hot air gun.
To change the handle position:
•
Press the release button (8)
•
Turn the handle to the desired position
•
Make sure that the release button has
been locked again.
Always use with caution! Do NOT
cover the ventilation openings during
use as it causes a risk of burns!
Do not touch the hot nozzle!
.
English
15
10-12-15 11:03
Publicité
Table des Matières
