Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• You smell or see smoke caused by
scorched insulation from the hot air gun.
Electrical safety
4.4
When using electric machines always
observe the safety regulations applicable in
your country to reduce the risk of fire, elec-
tric shock and personal injury. Read the
following safety instructions and also the
enclosed safety instructions.
Always check that the power sup-
ply corresponds to the voltage on
the rating plate.
Class II machine – Double insula-
tion – You don't need any earthed
plug.
Replacing cables or plugs
4.5
If the power cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person, in
order to avoid a hazard.
Immediately throw away old cables or plugs
when they have been replaced by new ones.
It is dangerous to insert the plug of a loose
cable in the wall outlet.
Using extension cables
4.6
Only use an approved extension cable suita-
ble for the power input of the machine. The
minimum conductor size is 1.5 mm
using a cable reel always unwind the reel
completely.
Inadequate extension cords can be danger-
ous. If an extension cord is used, it shall be
suitable for outdoor use, and the connection
has to be kept dry and off the ground. It is
recommended that this is accomplished by
means of a cord reel which keeps the
socket at least 60 mm above the ground.
5. Contents
1× Electric weed killer
1× Nozzle for surface weed control
1× Heating pin for underground weed
control
2× Nozzles for paint removal
1× Nozzle for BBQ
1× Extension handle (2 parts)
1× Instruction manual
6. Product
(See Fig. A)
1.
On / off switch
2. Temperature switch
3. Ventilation openings
4. Hot air nozzle
5. Extension handle
6. Handle
7.
Lock button for extension handle
8. Lock button for revolving handle
9.
Cap
10. Stand
11. Nozzle for surface weed control
12. Flat nozzle for paint removal
13. Glass protection nozzle for paint
removal
. When
2
14. BBQ / fireplace nozzle
15. Heating pin for underground weed
control
7. Operation
Temperature settings:
7.1
With the temperature switch you can select
from three temperature settings. Depending
on the application, you can use the follow-
ing settings:
Setting I 50 °C (venting / cooling)
Setting II 400 °C
Setting II 600 °C
The volume of air in each setting 500L /
Minute.
To turn on the power:
7.2
— Press the on / off switch (1).
Always use with caution! Do NOT
cover the ventilation openings dur-
ing use as it causes a risk of burns!
Do not touch the hot nozzle!
English
7
Publicité
Table des Matières
