Progress PI1535 Notice D'utilisation page 30

30 progress
Malfunction
The anti-flood device is on.
The start of the washing pro-
gramme does not occur.
After the check, turn the programme knob
on the same washing programme before
the malfunction occurred. The programme
continues from the point of interruption.
If the malfunction occurs again, contact the
service centre.
If the different alarm codes show, contact
the service centre.
The necessary information for the service
centre is on the rating plate.
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Limescale particles on the
dishes.
Possible cause
The connection of the water
drain hose is not correct.
The water drain hose is dam-
aged.
The appliance door is open.
You did not press the start/
cancel button.
The mains plug is not connec-
ted in the mains socket.
The fuse in the fuse box is
damaged.
The delay start is set.
Record this information:
– Model
(MOD.) ....................................................
....
– Product number
(PNC) ..........................................
– Serial number
(S.N.) ..............................................
Possible cause
The selected washing pro-
gramme was not applicable for
the type of load and soil.
The baskets were not loaded
correctly, water did not touch
all surfaces.
The spray arms could not turn
freely because of incorrect ar-
rangement of the load.
The filters are dirty or not as-
sembled and installed correctly.
The quantity of detergent was
not sufficient or missing.
The salt container is empty.
Incorrect water softener adjust-
ment
Possible solution
Make sure that the connection
is correct.
Make sure that the water drain
hose has no damages.
Close the water tap and con-
tact the service centre.
Close the appliance door.
Press the start/cancel button.
Connect the mains plug.
Replace the fuse.
• Cancel the delay start.
• When the countdown is
completed, the washing pro-
gramme starts automatically.
Possible solution
Make sure that the washing
programme is applicable for the
type of load and soil.
Load the baskets correctly.
Make sure that an incorrect ar-
rangement of the load does not
cause a blockage of the spray
arms.
Make sure that the filters are
clean and correctly assembled
and installed.
Make sure that the quantity of
detergent is sufficient.
Fill the salt container with dish-
washer salt.
Adjust the water softener.