Maintenance And Cleaning; Service; Warranty - Parkside PDFP 500 A1 Instructions D'utilisation Et Consignes De Sécurité

Initial use / Maintenance and Cleaning / Service / Warranty
regulator as described below under "Increas-
7
ing the air quantity" up to the maximum setting.
Increasing the air quantity:
Note: Increasing the amount of air is generally
advisable when the degree of atomization is too
coarse.
T urn the air quantity regulator
clockwise direction.
Reducing the air quantity:
Note: Reducing the amount of air is generally
advisable when the paint spray is too strong.
T urn the air quantity regulator
wise direction.

Maintenance and Cleaning

Note: Thorough cleaning after each use is very
important for safety and operation.
Otherwise, for example, the needle will become
clogged and the proper functioning of the appliance
can no longer be guaranteed.
Wear suitable protective gloves
when carrying out cleaning work.
Do not use any hydrocarbon-containing halo-
gen solvents, such as trichloromethyl, ethyl
chloride, etc., as they undergo chemical reac-
tions with some materials of the paint spray
gun. This can lead to dangerous reactions.
ATTENTION! Never immerse the paint spray
gun completely in solvent.
After each use, spray thinner (only in the open
air – danger of explosion!) or water
through the device.
To clean the casing, nozzle head
spray holes inside it, use a cloth or the cleaning
brush provided.. Never use petrol, solvents or
cleaning agents that attack plastic.
First unscrew the stroke stop screw
it anti-clockwise .
Remove the spring
Remove the needle
(see Fig. A).
Clean the needle
10
also refer to Fig. B.
26 GB
in an anti-
7
in a clock-
7
and the
9
by turning
4
.
11
with the aid of pliers
10
carefully with the brush
Replace the needle
Position the spring
Tighten the stroke stop screw
clockwise
Unscrew the flow cup
ning anticlockwise
Remove the filter
clean it with the cleaning brush.
Clean the interior screw thread
cup with the cleaning brush (see Fig. D).
3
Replace the filter in the gun (see Fig. C) and tigh-
ten the flow cup
For rust protection you can spray sewing ma-
chine oil through the device after cleaning.
Lubricate all moving parts from time to time.
After cleaning the needle, the thread and seal
must be lightly treated with grease.
Do not use any lubricants containing silicone.
Only store compressed air tools in dry areas.

Service

ated equipment should only be repaired
by qualified specialists and with original
spare parts. This will ensure that devices
remain safe.

Warranty

The warranty for this appliance is for 3
years from the date of purchase. The ap-
pliance has been manufactured with care
and meticulously examined before deliv-
ery. Please retain your receipt as proof of
purchase. In the event of a warranty claim,
please make contact by telephone with our
Service Department. Only in this way can a
post-free despatch for your goods be assured.
The warranty covers only claims for material and
maufacturing defects, but not for transport damage,
for wearing parts or for damage to fragile compo-
nents, e.g. buttons or batteries. This product is for pri-
, vate use only and is not intended for commercial use.
12
in the paint spray gun.
10
on the end of the needle
11
by turning it
4
.
from the gun by tur-
3
.
, as shown in Figure C, and
13
of the flow
14
by turning it clockwise
3
Compressed air-oper-
.
10
.