Scheppach ts 30 Traduction Du Manuel D'origine page 45

Warning: In the interests of operational safety, always switch off the saw and remove the mains plug before carrying out maintenance
work.
Problem
Fastening nut tightened insufficiently
Saw blade gets loose after
turning off the motor
Motor does not start a) Fastening nut tightened insufficiently
b) Extension cable defect
c) Connections on the motor or switch defect
No motor output turns off Overload by dull saw blade, thermoprotection is
automatically triggered
Burns on the cutting a) Fastening nut tightened insufficiently
surface b) Wrong saw blade
c) with longitudinal cuts c) Longitudinal stop not parallel
d) with cross cuts
d) Slide carriage not parallel
Troubleshooting table
Possible Cause Help
Tighten fastening nut, M20 left-handed thread
a) Check the mains fuse.
b) See "Electrical Connection" in the operating
manual
c) Have it checked by an electrician
Insert a sharpened saw blade; motor can be
turned on again after the cooling period
a) Insert a sharpened saw blade
b) Insert saw blade with 20 or 28 teeth for
longitudinal cuts
c) Exchange the longitudinal stop
Align the slide carriage with the saw blade
45