Zanussi ZWY 1100 Notice D'utilisation page 8

Problems
The washing results are not
satisfactory :
The appliance vibrates, is
noisy:
The wash cycle is much too
long:
The appliance stops during a
wash cycle:
The lid doesn't open at the
end of the cycle:
Softener runs directly into
the drum when filling the
dispenser box:
The drainage pump runs
constantly, even when the
appliance is inactive:
The "Start/Pause" pushbut-
1) 2)
ton flashes red :
1) On some models, the audible signals can sound
2) After solving any problems, press "Start/Pause" pushbutton to restart the interrupted programme.
8
• the detergent is unsuitable for machine washing,
• there is too much washing in the drum,
• the wash cycle is unsuitable,
• there isn't enough detergent.
• all packaging have not been removed from the appliance (see "Installation"),
• the appliance isn't level and is unbalanced (see "Installation"),
• the appliance is too close to the wall or furniture,
• washing is unevenly distributed in the drum, the load is too small,
• the appliance is in running in period, noise will disappear with time.
• the water inlet filters are dirty (see "Care and cleaning "),
• the power or water supply has been cut off,
• the motor overheating detector has been activated,
• the water inlet temperature is lower than usual,
• the foam detection security system has been activated (too much detergent) and the
washing machine has begun draining the foam,
• the out of balance detector has been activated: an extra phase has been added to
distribute washing more evenly in the drum.
• the water or electricity supply is defective,
• a "Rinse hold" has been selected,
• the drum shutters are open.
• the temperature inside the drum is too high,
• the lid unlocks 1 - 2 minutes after the end of the cycle.
• you have gone past the MAX indicator.
• the anti-flooding security system has been activated, please proceed as follows :
- close the water inlet tap,
- empty the appliance for 2 minutes before unplugging,
- call the after-sales service.
• the lid is not closed properly,
• the drainage filter is obstructed,
• the drain hose is blocked or bent,
• the drain hose is fixed to high (see "Installation"),
• the drainage pump is blocked,
• the standpipes blocked,
• the water tap is closed, the water supply has been cut off.
Causes