Publicité
Les langues disponibles
Les langues disponibles
Compatibility.
5. Securely tighten cup cover onto cup support.
6. Align VacuValve on cup cover with Prime Pump/Spray
knob. Push cup assembly onto sprayer and twist to lock.
7. Install battery onto sprayer.
8. Make certain the Prime Pump/Spray knob is in the Pri-
me Pump position (pointed down). Set speed control to
10.
9. Turn the sprayer upside down and point the sprayer
into a waste pail. Pull the trigger for three seconds.
10. Turn Prime Pump/Spray knob forward to SPRAY posi-
tion. Rotate spray tip 180 degrees to UNCLOG position.
SPRAY
11. While holding the sprayer upside down point the spra-
yer into a waste pail. Pull the trigger for three seconds.
IMPORTANT:
For best results, do not spray more than one cup of water
through the tip while cleaning. If more flushing is needed,
remove the tip from the sprayer to avoid excessive wear.
12. Sprayer is now flushed and ready for use. See Start
Up.
IMPORTANT:
The motor has a built-in feature to protect itself from
overuse. If the motor stops, the thermal switch has trip-
ped.
The motor will operate normally after cooling for 20 - 30
minutes.
121
CLEANUP
Original instruction
Publicité
