Publicité
Les langues disponibles
Les langues disponibles
• Repeat steps 2- 6 to ensure all the air is evacuated from
the Cup insert.
• Make certain the Prime Pump/Spray knob is in the
Spray position.
• If sprayer still does not spray, see Sprayer Diagnostics.
If material sprays while upside down there is air in the
cup. Repeat steps above.
• Replace VacuValve cap. Two new VacuValve caps came
with your sprayer.
Refilling Cup insert
If sprayer runs out of paint simply separate the cup sup-
port from the cup cover/sprayer and refill the Cup insert.
1. Remove battery from the sprayer.
2. Separate the cup support from the cup cover/sprayer.
Set the sprayer upside down on a flat surface. This will
keep the wet paint in the cup cover.
Processable materials
A tip FF PRO
Spray width*
10 cm
15cm
20cm
25cm
Rotational speed
*First tip code digit multiplied by 5 = spray width in cm at a distance of approximately 25 cm to the coating surface -
example with 208: 2 x 5 = 10 cm
Original instruction
3. Follow steps 2 - 12 in Starting a New Job.
How to Spray
Take a few moments prior to spraying and review these
simple tips to ensure your spraying project is a success.
NOTE:
For proper sprayer operation use only a tip from the same
tip family that came with your sprayer.
Speed control
Gradual pressure adaptation with speed control. Always
start with the lowest speed to reduce overspray to guaran-
tee a uniform spray pattern.
Tip and Pressure Selection
See table for recommended spray pressure for your mate-
rial. Refer to paint (material) can for manufacturer's
recommendations.
Glazes, alkyd resin coatings, acrylic lacquers
Tip hole in 1/1000" (example 8 = 0.008") and tip markings
8
10
208
308
410
1 - 5
1 - 10
114
Primers, pre-coats,
emulsion
12
16
412
516
6 - 10
Publicité
