Set A Shut Off Timer "Ht; Lock A Temperature / Airflow Setting "Loc; Setting The Temperature Unit "C-F - TOOLCRAFT LSH-880 Mode D'emploi

b) Set a shut off timer "Ht"
Note
• If the set time is too low, heating will stop as soon as the timer reaches working temperature. Experiment with
different values to get the best results.
• The air gun will stop heating after the set time. Non-heated air will flow through until it has been cooled to
<100 °C.
• Put the handle on the holder and then remove it again to resume use after the timer has run down.
1. Enter the settings menu and navigate to "Ht".
2. Choose a timer setting: "OFF", 10 - 900 seconds.
3. Save the setting and exit.
c) Lock a temperature / airflow setting "Loc"
You can lock the temperature and airflow at the current settings.
1. First set the desired working temperature and airflow on the workstation.
2. Enter the settings menu and navigate to "Loc".
3. Choose a setting of "on" or "off".
4. Save the setting and exit. A lock icon
d) Setting the temperature unit "C-F"
1. Enter the settings menu and navigate to "C - F".
2. Select a unit of temperature °C or °F.
3. Save the setting and exit.
32
will show to indicate the temperature / airflow is on.