Remote Control - HQ Power VDPLB408WL Mode D'emploi

6.

Remote Control

Refer to the illustrations on page 2 of this manual.
key step 1
blackout
1
auto
2
sound
3
strobe
4
speed
5
sensitivity
6
%
7
manual
8
fade
9
RGBW
10
+/-
11
0-9
12
7. Installation
Choose a suitable mounting spot. Connect the power cord to the mains and switch on [7]. Switch off and
disconnect after use.
Mounting the Device

Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.

The carrying construction must be able to support 10 times the weight of the device for 1 hour
without deforming.

The installation must always be secured with a secondary attachment e.g. a safety cable.

Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.

Install the device in a location with few passers-by that is inaccessible to unauthorised persons.

Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.

For truss mounting, use appropriate clamps and brackets.

Make sure there is no flammable material within a 0.5 m radius of the device.

Have a qualified electrician carry out the electric connection.

Connect the device to the mains with the power plug. All devices must be powered directly off a
grounded switched circuit and cannot be run off a rheostat or dimmer circuit, even if the rheostat or
V. 01 – 19/11/2014
step 2 step 3
any key
+/-
speed +/-
strobe +/-
% +/-
sensitivity +/-
strobe +/-
% +/-
+/-
+/-
+/-
+/-
RGBW +/-
strobe +/-
% +/-
+/-
speed +/-
strobe +/-
% +/-
+/-
strobe +/-
% +/-
function +/-
strobe
% +/-
VDPLB408WL
Auto programme mode
Sound mode
Dimmer
Auto programme speed
Sensitivity for sound mode
Manual RGBW mode
Value setting
Strobe speed
Fading mode
Manual colour selection
6
description
©Velleman nv