Technical Specifications - HQ Power VDPLB408WL Mode D'emploi


Do not immerse the device in any liquid.

There are no user-serviceable parts, apart from the fuse.

Contact your dealer for spare parts if necessary.
Replacing the Fuse
Only replace the fuse by a fuse of the same type and rating.
1. Before replacing the fuse, switch off the device and unplug the mains lead.
2. Remove the fuse holder [8] on the underside of the base.
3. Remove the old fuse and install the new fuse in the fuse holder.
4. Replace the fuse holder in the housing and tighten it.
10.

Technical Specifications

power supply
charging time
autonomy
power consumption
IP rate
LEDs
beam angle
field angle
dimensions
weight
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulting from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual, please visit our website
www.hqpower.eu. The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part
of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
V. 01 – 19/11/2014
VDPLB408WL
100-240 VAC, 50/60 Hz
5 h
full mode
± 8 h
39 W
IP30
4 x 8 W RGBW
13°
30°
137 x 145 x 191 mm
3.4 kg
11
single colour mode
± 20 h
©Velleman nv