Control Panel - HQ Power HQLP10014 Mode D'emploi

4.3 Connection

Have a qualified electrician carry out the electric connection.

Connect the device to the mains with the power plug. All devices must be powered
directly off a grounded switched circuit. Do not connect to a dimmer pack.

The installation has to be approved by an expert before the device is taken into
service.
5. Operation
The device can be used in the following modes:

stand-alone mode

master/slave

with a DMX-512 controller.
5.1

Control Panel

Access the control panel functions using the four panel buttons located around the display.
Menu scroll through the menu options
upwards through the menu list
downwards through the menu list
Enter confirm a selection
5.2 Menu
mode
DMX mode
static colours
auto mode
sound mode
speed
mic sensitivity
edit colour
dimming
silent scene
slave
IR
5.3 Stand-Alone Mode
The device starts running in stand-alone mode after connection to the mains. This mode allows you to
use the device without controller.
5.4 Master/Slave Mode

The master/slave mode allows for connecting several devices to a single master device in a daisy chain.

All slave devices will then work synchronously with the master device.

Configure all slave units before connecting the master unit to the daisy chain.
V. 03 – 24/11/2017
HQLP10014
programme
29CH d001-d484
19CH d001-d494
9CH d001-d504
2CH d001-d512
C-- C01-21
Auto Au1-7
Soun So1-7
SPEE SP1-9
SEnS SE1-9
r000-255
g000-255
Colo
b000-255
U000-255
dIMM
SILE on/oFF
SLAV
InFr on/oFF
dl1-9
silent scene at sound programme
Slave
8
description
29 channels
19 channels
9 channels
2 channels
static colours
auto programme
sound programme
speed
microphone sensitivity
red
green
blue
white
master dimming
slave mode
enable/disable IR remote
©Velleman nv