Technical Data - VOLTCRAFT ST-100 Notice D'emploi

Error
The multimeter does not work.
No measured value change.
The scale display of the sat fi nder is not lit.
Repairs other than those described above must only be carried out by an authorised
specialist.
If you have any questions about handling the meter, our technical support is available
under the following telephone number:
Voltcraft®, 92242 Hirschau, Lindenweg 15,
phone no. (+49) (0) 96 04 / 40 87 80

14. TECHNICAL DATA

Display ................................................2000 counts
Auto-Power OFF .................................after approx. 15 minutes, a signal sounds; deactivation
Input resistance ..................................>7.5 MΩ
Measuring type ...................................Average measurement
Operating voltage ...............................DMM: 3 V/DC (2 x AAA)
Operating altitude ...............................Max. 2000 m above sea level
Degree of contamination ....................2
Working temperature ..........................0°C to +40°C
Storage temperature ...........................-10°C to +50°C
Weight ................................................Approx. 308 g
Dimensions (LxWxH) ..........................162 x 75 x 44 (mm)
Possible cause
Are the batteries dead?
Check the status.
Is the HOLD function activated?
The sat system is not switched on.
The cables are not connected correctly.
DC-uncouple connection sockets were used
takes place after another minute.
Sat-Finder: 13 - 18 V/DC
43