Before Calling Your After Sales Service - BORETTI BV-89 Notice D'emploi

• This appliance is provided with a special drain system.
1. Pull out the bottom drawer
aligning it to the cabinet front.
2. Pull out the drain pipe
place it in the groove on the front side of the floor of the appliance.
3. If there Is still water on the freezer floor, you can clear it away by using a sponge.
• Clean the interior by hand with lukewarm water and a little detergent. Never use abrasive
products or aggressive cleaning agents.
• Dry the inside of the unit, plug on the mains, and set the thermostat knob to position "5".
After 24 hours, reset the thermostat to the desired position.
PART 5.

BEFORE CALLING YOUR AFTER SALES SERVICE

If your refrigerator is not working properly, it may be a minor problem, therefore check the
following.
The appliance does not operate, Check if;
• There is a power failure,
• The mains plug is not properly plugged in, or is loose
• The thermostat setting is on position "0",
• The socket is defective. To check this, plug in another appliance that you know which is
working into the same socket.
A of the freezer compartment and put it on the floor
B placed on the back wall of the freezer compartment. Then