Problems And Solutions - Rotel U1573CH Mode D'emploi


When a programme is shown in the display, turn the time controller (C) a little
to the right and press the "Start/Reset" button (D) twice at short intervals (the
appliance turns on briefly and then turns off again).

The display will now show "0.00".

Press the "Start/Reset" button (D) until (approx. 3sec) you hear a beep. The
lock symbol appears in the display.

To turn the lock off again press the "Start/Reset" button again until (around 3
seconds) until you hear a beep again.
 CLEANING
o
To get rid of any unpleasant odours inside the microwave, you can set the "Clean"
programme running (only works with the ventilator):
The microwave must be empty.
1.
Turn the programme controller (B) to the position "Clean".
2.
Set the cleaning time you want (1-15 minutes) using the time controller (C).
3.
Press the "Start/Reset" button (D).
4.
o
Disconnect the appliance from the mains.
o
Clean the oven area after use with a slightly damp cloth.
o
Clean the accessories in the usual way with soapy water.
o
The frame of the door and its seal must be carefully cleaned along with all the
adjacent parts using a damp cloth.
o
This appliance complies with the relevant CE directives and built in compliance with
the latest safety regulations.
o
We reserve the right to make technical changes.
 PROBLEMS AND SOLUTIONS
o
If you cannot rectify a problem yourself with the help of the following Troubleshooting
Table, please contact a qualified technician.
o
The appliance does not start

Is the appliance connected to the mains?

Is the door closed properly?

Have you entered the cooking time?
o
Sparks

Are you using the right kind of cookware?

Is the appliance empty?
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use