Proxxon Thermocut 12/E Mode D'emploi page 11

3. Fix the position by tightening the clamping screw 1
Adjusting the bottom wire holder (Fig. 3):
Caution! You can make these adjustments before clamping the hot wire, but you
can also correct the position afterwards!
1. Release clamping screw 1
2. The wire holder can now be drawn in and out. Make the necessary adjustment.
3. Fix the position by tightening the clamping screw 1
Fasten the hot wire (Fig. 4)
1. Release clamping screws 1
2. Insert wire 2 in the clamping slits and position as desired
3. Tighten clamping screws 1
Replacement cutting wire available under article number 28082 (package of 10)
EC Declaration of Conformity
Name and address:
PROXXON S.A.
6-10, Härebierg
L-6868 Wecker
Product designation
Thermocut 12/E
Article No.: 27082
In sole responsibility, we declare that this product conforms to the following stan-
dards and normative documents:
EU-EMC Directive 2004/108//EEC
DIN EN 55014-1 / 06.2007
DIN EN 55014-2 / 08.2002
DIN EN 61000-3-2 / 10.2006
DIN EN 61000-3-3 / 06.2006
Date: 21. November 2008
Useful notes:
Dipl.-Ing. Jörg Wagner
PROXXON S.A.
- 11 -