Proxxon Thermocut 12/E Mode D'emploi page 10

Scope of delivery:
1 Thermocut 12/E
5 cutting wires 200 x 0.85 mm
Specifications:
Voltage
Output
Cutting wire temperature:
Heating time:
Cutting wire thickness
Cutting wire length
Passage width:
Max. extension:
Polarity-protected PROXXON 12 V system plug.
To operate, we recommend MICROMOT power supplies with a current of 2.0 A.
Legend Fig. 1:
1. Grip
2. On-Off switch
3. Temperature control knob
4. Clamping screws for hot wire
5. Clamping screw for bottom wire holder
6. Clamping screw for top wire holder
7. Retaining clip
8. Supply cable
• The hot wire can heat up to 400°C during operation. Do not touch! Risk of burns!
• Make sure the hot cutting wire does not touch any electrical lines or objects!
• After use, always disconnect the mains plug of the power unit!
• Keep children away from the working area!
Thermocut 12/E operation:
Adjusting the top wire holder (Fig. 2):
Caution! You can make these adjustments before clamping the hot wire, but you can
also correct the position afterwards!
1. Release clamping screw 1
2. The wire holder can now be drawn in and out and also swivelled. Make the
necessary adjustment.
- 10 -
12 V
60 W
adjustable from approx. 150°C to 400°C.
1 sec.
0.85 mm
200 mm
100 mm
200 mm
Please note: