Installation, Programming And Maintenance; Installation - Zummo Z06 NATURE Manuel D'utilisation

7. INSTALLATION, PROGRAMMING AND MAINTENANCE


It is compulsory for the machine to be earthed to avoid the possibility of people being given shocks
or damage to the equipment.

The plug must be easily accessible once the installation is complete. The use of extension cables,
adaptors and multiple sockets is not permitted.

Machines installed without a Zummo cabinet must be placed on a flat surface at a minimum height
of 780 mm.

7.1. INSTALLATION


Attention! The machine weighs 52 Kg. When moving the machine, we suggest that this should be
accomplished by two people. The best way to lift the machine is to grab the rear of the machine
from underneath, with one hand and with the other hand, grab the squeezing tray from underneath,
as well (Fig. 18).

Place the machine on a sufficiently sturdy and stable base.

Make sure that the machine's voltage and frequency match the values of your electrical installation.
See the identification plate (Fig. 19).

Use an electrical outlet equipped with an effective ground connection (0.03A). This outlet should be
used exclusively by the juice extraction machine. Do not plug other appliances into the outlet.

Before operating the machine, wash all machine parts that will be in contact with juice: Balls, Blade,
Juice tray, Filter Tray, Filter and Front Cover.

Turn ON the power switch (Fig. 6 (I=On, O=Off)). If no message appears on the display (Fig. 20),
there is lack of power supply. Make sure you have connected the plug to a powered circuit and that
the power switch is switched on. Once this is done, the Programmer display will show one of the
following messages:
Disp. 1
Disp.3a
37
Disp. 2
Disp. 3b