Pole Chain Saw; Parts And Controls - IKRA IMKH 52 Manuel D'utilisation

5. POLE CHAIN SAW

Parts and Controls

3
5
9
1 = Saw Chain
2 = Guide Bar
3 = Oil Tank
4 = Oil Filler Cap
5 = Drive tube
6 = Chain Sprocket Cover
7 = Hook
8 = Chain Guard (Scabbard)
9 = Locking pin (angular adjustment)
Using the Pole Pruner
Preparations:
• Wear suitable protective clothing and equipment – see
„Safety Precautions".
• Start the engine.
• Put on the shoulder strap.
Never throw cuttings into the household garbage
can – they can be composted!
Never stand directly under the branch you are cut-
ting – be wary of falling branches. Note that a branch
may spring back at you after it hits the ground!
Cutting sequence
To allow branches a free fall, always cut the lower branch-
es first. Prune heavy branches (large diameter) in several
controllable pieces.
Working position
Hold the control handle with your right hand, and the drive
tube with your left hand. Your left arm should be extended
to the most comfortable position.
8
4
1
2
7
6
The shaft should always be held at an angle of 60° or
less!
The most convenient working position is a tool angle of
60°, but any lesser angle may be used to suit the situa-
tion concerned.
Cross-cutting
To avoid pinching the bar in the cut, position the cutting
attachment with the hook against the branch and then
perform the cross-cut from the top downwards.
Relieving cut
GB-22