Installation Preparations; Installation; Fan Installation - Maico EHD 10 Instructions De Montage

8. Installation preparations

Risk of cuts from metal
housing plates with sharp
edges.
CAUTION
Wear protective gloves.
Notes
● Observe the permissible roof load.
● Correctly install ventilation ducts.
● Unpack fan unit. Dispose of packaging
material ( chapter 14).
● Lay a permanent power cable to the
installation location.
● Always note the relevant specifications
for electrical installations and when fitting
equipment. In Germany observe DIN
VDE 0100 and the corresponding parts
in particular.
● To prevent transmission of vibrations to
the duct system, use flexible fixing cuffs
(ELR type)
● To prevent leakages, screw the EHD roof
socket only onto a suitable even base. In
order to fit the EHD unit directly on the
ventilation duct, remove the EHD roof
socket (3 tapping screws).
● Use suitable insulation, sound-deadening
and installation material between the unit
and roof socket.
● With a free inlet, fit a protective grille (type
SGR) in front of the fan housing [7].
8. Installation preparations │ uk

9. Installation

9.1 Fan installation

Danger of injury from incorrect
installation location or
insufficient attachment to the
DANGER
ceiling or duct.
1. Only fit in places with suffi-
cient load-bearing capacity.
2. The customer should provide
mounting material of a
sufficient size (screws with
diameter of 10 mm, min.
strength class 8.8).
3. Screw unit tightly to the roof
or roof socket.
Risk of cuts from metal
housing plates with sharp
edges.
CAUTION
Wear protective gloves.
Risks of leakages if unit not
NOTICE
sealed tightly enough.
1. Screw unit tightly with all
screws.
2. Fit suitable insulation, sound-
deadening and installation
material.
Attachment to roof or roof socket
1. Remove the 3 screws of the upper part of
housing [1] and lift this part up and off.
17