Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
- Lampset : lamp setup
- Default : lamp default setup ( Loamp off ( Wink ), Lamp on ( ilum ))
- Control : Lamp state control ( Manual lamp off ( Wink ), Manual lamp on ( Ilum ))
- DMX lamp : DMX lamp control ( DMX lamp control disable ( Off ), DMX lamp control enable ( Open ))
- Lamptime : Lamp Used time
- Cleartim : Reset lamp used time ( Enter password ( ) then Ilum to reset )
- : To return to previous menu
Infosee : informations about moving head components
- Workhour : Working hours memo for connect power
- Open : Open time memo
- Fan1rota : Fan rotation speed 1
- Fan2rota : Fan rotation speed 2
- Version : version of built-in software
- Spare time : Delay between each technical revision
- Spare cut :
- Control : Control the channel
- Assitool : parameters setup
- Factory : Loading factory setups (Enter password ( ) then Fold to load factory setup or Save to save your
own setups )
- Default : load default setups (Enter password ( ) then Fold to load default setups )
- Redress : Reset composants (Enter password ( ) then set components
- Chdefine : DMX channel by define
- Brighne : Enter password ( ) then
- Timelimi : Open fixture time limit
- Timslimi : Fixture time limit
- Timeclea : Clear the time of used
- Cutclea : Clear the time of used
- Passwor1 : Revise password 1
- Passwor2 : Revise password 2
- Passwor3 : Revise password 3
- Passwor4 : Revise password 4
- Xdrivin : pan main drive gear
- Xdriven : Pan slave drive gear
- Ydrivin : Tilt main drive gear
- Ydriven : VitessTilt slave drive gear
- Lamppowe : Ballast eathed or ballast 5V
- Yangle : Tilt angle set
- : To return to previous menu
- chanleve : Manual mode for each channel
- All reset : total reset ( select Exec to validate )
© Copyright LOTRONIC 2015
BEAM7R
Page 6
Publicité
Table des Matières
