General Guidelines - afx light DMX MOVING HEAD 7R 230W Manuel D'utilisation

Thank you for having chosen our AFX LIGHT MOVING HEAD WITH DMX CONTROL. For your own safety, please
read this user manual carefully before installing the device.
SAFETY INTRODUCTION
 If the device has been exposed to temperature changes due to environmental changes, do not switch it on
immediately. The arising condensation could damage the device. Leave the device switched off until it has
reached room temperature.
 Don't move the unit when it's running as this might damage the lamp. The warranty doesn't cover this
type of damage that is caused by wrong use.
 It is essential that the device is earthed. A qualified person must carry out the electric connection.
 Make sure that the available voltage is not higher than stated at the end of this manual.
 Make sure the power cord is never crimped or damaged. If it is damaged, ask your dealer or authorized agent to
replace the power cord.
 Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the power cord
by the plug. Never pull out the plug by tugging the power cord.
 During initial start-up, some smoke or smell may arise. This is normal and should decrease gradually.
 DISCONNECT DEVICE: Where the MAINS plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.
 Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to such an extent
that their effectiveness is impaired, for example by cracks or deep scratches.
 Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to such an extent
that their effectiveness is impaired, for example by cracks or deep scratches.
 The lamp shall be changed if it has become damaged or thermally deformed
CAUTION:
1. Be very careful during installation. Since you will be working with a dangerous voltage you can suffer a
life-threatening electric shock when touching live wired.
2. Never look directly into the light source, as sensitive persons may suffer an epileptic shock.
3. Please be aware that damages caused by manual modifications to the device are not subject to warranty. Keep
away from children and non-professionals.
4. The light doesn't include any spare parts for repair, please check if all the parts are well installed and screws are
fitted tightly before operating. Do not use the light when the cover is open.

GENERAL GUIDELINES

 This device is only allowed to be operated with an alternating current of max. 110-240VAC/50-60Hz and was
designed for indoor use only.
 Do not shake the device. Avoid brute force when installing or operating it.
 When choosing the installation spot, please make sure that the device is not exposed to extreme heat, moisture
or dust. The minimum distance between light-output from the projector and the illuminated surface must be more
than 1 meter. Keep a distance to any flammable objects of at least 5m.
 Operate the device only after having familiarized yourself with its functions. Do not permit operation by person not
qualified for operating the device. Most damages are the result of unprofessional operation.
 Please use the original packaging if the device is to be transported.
 For safety reasons, please be aware that all modifications on the device are forbidden. Furthermore, any other
operation may lead to short-circuit, burns, electric shock, lamp explosion, crash, etc. If this device will be
© Copyright LOTRONIC 2015
GB
BEAM7R Page 3