afx light DMX MOVING HEAD 7R 230W Manuel D'utilisation page 12

LAMP REPLACE
When you want to replace the lamp, it's forbidden to touch lamp with bare hand to avoid greasy dirt stains filament.
Filament must be clean
1) Disconnect the power cable. Before replace lamp, device need 20min for lamp cooling. Fasten the head
with Y protect lock in 60° position
2) Use cross screwdriver to open the light body cover ( picture 1 )
Picture 1
3) After open the cover, you can see the lamp inside, please wait the lamp cool after used but not touch it in hot
status ( picture 2 )
Picture 2
4) With one hand, press the lamp holder and with another hand, hold the lamp and pull out the wire
( picture 3 & 4 )
Picture 3
5) After take apart the lamp, please check the inside glasses, clear it will make the light better effect (picture 5)
Picture 5
6) Installed the lamp after replaced
© Copyright LOTRONIC 2015
Picture 4
BEAM7R Page 12