Control Panel • Functions - INVENTOR PR-ION-20L Manuel D'utilisateur

8. CONTROL PANEL • FUNCTIONS
POWER
By pressing the "POWER" button the dehumidifier turns on or off. The "Power" button and Display
will turn on.
• When the set humidity is reached, the Energy Savings function is automatically
activated during which the digital control display of the device may show increased
humidity levels. This is because the fan is not operating. After the predetermined
timeframe and if the humidity levels have increased, the device will resume
dehumidification.
• In the event of a power failure the unit has an Auto Restart function. Once power
is restored, the appliance will automatically restart at the preselected settings prior
to the power failure.
MODE
By pressing the "MODE" button, various operations may be selected (Dryer, Cont., Smart).
While changing operation modes, device will make a short beep.
Dryer
Dryer mode: When this function is selected the device operates under Turbo Fan Speed.
After operating for approximately 2 hours the unit will check the room's humidity. If under
45%RH, only the fan will operate for two hours. After the 2 hours, the unit will quit dryer
mode. If over 45%RH, the unit will operate in Turbo fan Speed for 1 hour before checking the
room's humidity again. The maximum operation time set by this mode is 10 hours and can
be reduced depending on the room size and the dampness of the clothes.
• For drying clothes: place the dehumidifier in a small room and set nearby the
clothes rack. Keep doors shut and allow the dehumidifier to dry the clothes.
• For optimal results manual wringing of the clothes is suggested.
• Allow 30-50cm distance from the moist clothes.
Cont.
Continuous function: the dehumidifier operates continuously when the drainage pipe is
attached, or until the water tank is full, extracting humidity from the air. When this function is
active the indicator will turn on and the device will work constantly, disregarding the relative
humidity of the room and the desired humidity level set.
• For special humidity conditions where big amounts of condensation need to be
extracted, such as extremely moist rooms.
EN
45
17