Control Panel • Functions - INVENTOR PR1-ION10L Manuel De L'utilisateur

6. CONTROL PANEL • FUNCTIONS
POWER
By pressing the "POWER" button the dehumidifier turns on or off. The "Power" button and
Display will turn on.
• When set humidity level has been reached the unit's compressor will
automatically stop as soon as the humidity level drops 3%-5% under the set
humidity level. The fan will continue operating for a while and will stop as
soon as the humidity remains below the desired level.
• In the event of a power failure the unit has an Auto Restart function. Once
power is restored, the appliance will automatically restart at the preselected
settings prior to the power failure.
MODE
By pressing the "MODE" button, various operations may be selected (Dryer, Cont., SMD).
While changing operation modes, device will make a short beep.
Dryer
Dryer mode: When this function is selected the device operates under Turbo Fan Speed.
After operating for approximately 2 hours the unit will check the room's humidity. If
under 45%RH, only the fan will operate for two hours. After the 2 hours, the unit will quit
dryer mode. If over 45%RH, the unit will operate in Turbo fan Speed for 1 hour before
checking the room's humidity again. The maximum operation time set by this mode is 10
hours and can be reduced depending on the room size and the dampness of the clothes.
• For drying clothes: place the dehumidifier in a small room and set nearby the
clothes rack. Keep doors shut and allow the dehumidifier to dry the clothes.
• For optimal results manual wringing of the clothes is suggested.
• Allow 30-50cm distance from the moist clothes.
Cont.
Continuous function: the dehumidifier operates continuously when the drainage
pipe is attached, or until the water tank is full, extracting humidity from the air. When
this function is active the indicator will turn on and the device will work constantly,
disregarding the relative humidity of the room and the desired humidity level set.
EN
9