Water Tank & Drain Hose - INVENTOR PR-ION-20L Manuel D'utilisateur

9. WATER TANK & DRAIN HOSE
There are two ways to remove collected water. Before proceeding ensure that you have switched
off and unplugged the unit.
1. Usage of the water
When unit is OFF and the tank of the dehumidifier is full, the full indicator will be lit, and the
display will read P2. Additionally, when the unit is on and the tank is full, the compressor stops
operation followed by the fan a few minutes later. The full indicator will flash and the display
will show P2.
• Slowly remove the bucket. Grip the handle with caution, and carefully pull outwards so
the water does not overflow. Do not place the tank on the floor because the bottom of the tank
is uneven. Doing so the tank will fall and the water will be spilled on the floor.
• Empty the water from the tank and place it again in to the device. The water tank, must be
securely and properly placed, for the dehumidifier to operate.
• When the water tank is re-installed the unit will automatically restart.
2. Continuous draining
Water automatically can be emptied into a floor drain by
attaching the unit with a water hose.
• Remove the rubber plug located opposite the unit.
Insert the water hose into the drain outlet and make sure all
connections are firmly tightened in order to avoid any possible
leaks.
• The dehumidifier should be placed on a flat surface in an
upright position.
• Lead the water hose towards a suitable drainage facility and
be certain that the water flows naturally. For correct drainage,
make sure the hose stays below the level of the drain hose
outlet.
EN
• When you remove the tank, do not touch any parts inside
the unit, as you may damage the device.
• Be sure to gently place the tank into the dehumidifier.
• Do not drink or use the collected water from the device.
• Wipe any excess water on, or in, the unit when removing
the tank.
water drain
hose outlet
21