INVENTOR PR-ION-20L Manuel D'utilisateur page 26

The unit does not start
Make sure the dehumidifier's plug is placed completely into the socket.
l
Check the house fuse/circuit breaker box.
l
Check whether the power cord is damaged.
l
Check the water bucket, if it is full, empty it.
l
Check if the dehumidifier has reached its preset level.
l
Make sure the water bucket is positioned properly.
l
Room temperature is lower or higher than the advised operational range.
l
Check whether the humidity level has been set in high levels.
l
Dehumidifier does not dry the air as efficient
The humidity level is too high. Make sure that the dehumidifier has been operating enough
l
time to remove the moisture.
Make sure there are no curtains, blinds or any other obstacles blocking the front or back of
l
the dehumidifier.
The humidity selector may not be set low enough.
l
Make sure you have cleaned the filter as suggested. Clogged filter may result in reduced
l
performance.
All house exits (windows doors etc) where the dehumidifier is operating, should be shut.
l
Room temperature is below the advised operational range.
l
There is a kerosene heater or other heating type, giving off water vapor in the room.
l
The room that the device is placed is bigger than suggested.
l
The unit makes a loud noise when operating
The air filter is clogged.
l
The device is tilted instead of being in an upright position.
l
The floor surface is not flat.
l
Frost build up on coils
This is normal. This unit is supplied with an Auto defrost function. When the unit is operating
l
in low temperatures it is expected that the Auto defrost will activate more often.
Drain hose water leakage
Check the correct installation of the drain hose.
l
Check for any blockage or damage of the drain hose
l
Water on the Floor
Check if the rubber plug is firmly placed. A loose plug may result to a possible water leak.
l
Before removing the water bucket from the device allow a short period of time for any
l
additional accumulated water to be drained.
26
EN